Label: SODIUM CHLORIDE- sodium chloride injection

  • NDC Code(s): 63323-186-01, 63323-186-02, 63323-186-03, 63323-186-04, view more
    63323-186-10, 63323-186-20
  • Packager: Fresenius Kabi USA, LLC
  • Category: HUMAN PRESCRIPTION DRUG LABEL
  • DEA Schedule: None
  • Marketing Status: Abbreviated New Drug Application

Drug Label Information

Updated February 10, 2022

If you are a consumer or patient please visit this version.

  • DESCRIPTION:

    This preparation is designed solely for parenteral use only after addition of drugs that require dilution or must be dissolved in an aqueous vehicle prior to injection.

    Sodium Chloride Injection, USP, 0.9% is a sterile, nonpyrogenic solution. The osmolarity is 0.300 mOsmol/mL (calculated).

    Each mL contains: Sodium chloride 9 mg; Water for Injection q.s. It contains no bacteriostat, antimicrobial agent or added buffer and is supplied only in single dose containers. Hydrochloric acid and/or sodium hydroxide may have been added for pH adjustment (pH 4.5-7.0).

    Sodium chloride occurs as colorless cubic crystals or white crystalline powder and has a saline taste. Sodium chloride is freely soluble in water. It is soluble in glycerin and slightly soluble in alcohol.

    The empirical formula for sodium chloride is NaCl and the molecular weight is 58.44.

  • CLINICAL PHARMACOLOGY:

    Sodium chloride in water dissociates to provide sodium (Na+) and chloride (Cl) ions. These ions are normal constituents of the body fluids (principally extracellular) and are essential for maintaining electrolyte balance.

    The distribution and excretion of sodium (Na+) and chloride (Cl) are largely under the control of the kidney which maintains a balance between intake and output.

    The small volume of fluid and amount of sodium chloride provided by Sodium Chloride Injection, USP, 0.9%, when used only as an isotonic vehicle for parenteral injection of drugs, is unlikely to exert a significant effect on fluid and electrolyte balance except possibly in neonates and very small infants.

    Water is an essential constituent of all body tissues and accounts for approximately 70% of total body weight. Average normal adult daily requirement ranges from two to three liters (1 to 1.5 liters each for insensible water loss by perspiration and urine production).

    Water balance is maintained by various regulatory mechanisms. Water distribution depends primarily on the concentration of electrolytes in the body compartments and sodium (Na+) plays a major role in maintaining physiologic equilibrium.

  • INDICATIONS AND USAGE:

    This parenteral preparation is indicated only for diluting or dissolving drugs for intravenous, intramuscular, or subcutaneous injection, according to instructions of the manufacturer of the drug to be administered.

  • PRECAUTIONS:

    Consult the manufacturer's instructions for choice of vehicle, appropriate dilution or volume for dissolving the drugs to be injected, including the route and rate of injection. Inspect reconstituted (diluted or dissolved) drugs for clarity (if soluble) and freedom from unexpected precipitation or discoloration prior to administration.

    Pregnancy

    Animal reproduction studies have not been conducted with Sodium Chloride Injection, USP, 0.9%. It is also not known whether Sodium Chloride Injection containing additives can cause fetal harm when administered to a pregnant woman or can affect reproduction capacity. Sodium Chloride Injection, USP, 0.9% containing additives should be given to a pregnant woman only if clearly needed.

    Pediatric Use

    The safety and effectiveness in the pediatric population are based on the similarity of the clinical conditions of the pediatric and adult populations. In neonates or very small infants the volume of fluid may affect fluid and electrolyte balance.

    Drug Interactions

    Some drugs for injection may be incompatible in a given vehicle, or when combined in the same vehicle or in a vehicle containing benzyl alcohol. Consult with pharmacist, if available.

    Use aseptic technique for single or multiple entry and withdrawal from all containers.

    When diluting or dissolving drugs, mix thoroughly and use promptly.

    Do not store reconstituted solutions of drugs for injection unless otherwise directed by the manufacturer of the solute.

    Do not use unless the solution is clear and seal intact. Do not reuse single dose containers, discard unused portion.

  • ADVERSE REACTIONS:

    Reactions which may occur because of this solution, added drugs or the technique of reconstitution or administration include febrile response, local tenderness, abscess, tissue necrosis or infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection and extravasation.

    If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate countermeasures and, if possible, retrieve and save the remainder of the unused vehicle for examination.

  • OVERDOSAGE:

    Use only as a diluent or solvent. This parenteral preparation is unlikely to pose a threat of carbohydrate, sodium chloride or fluid overload except possibly in neonates or very small infants. In the event these should occur, reevaluate the patient and institute appropriate corrective measures. (See PRECAUTIONS and ADVERSE REACTIONS).

  • DOSAGE AND ADMINISTRATION:

    The volume of the preparation to be used for diluting or dissolving any drug for injection, is dependent on the vehicle concentration, dose and route of administration as recommended by the manufacturer.

    This parenteral should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit. See PRECAUTIONS.

  • HOW SUPPLIED:

    Sodium Chloride Injection, USP, 0.9%, preservative free, is available as follows:

    Product CodeUnit of SaleEach
    918602 63323-186-02
    Unit of 25
    NDC 63323-186-04
    2 mL fill, in a 3 mL
    Single Dose vial
    918610 63323-186-10
    Unit of 25
    NDC 63323-186-01
    10 mL Single Dose vial
    918620 63323-186-20
    Unit of 25
    NDC 63323-186-03
    20 mL Single Dose vial

    Preservative Free. Discard unused portion.

    Use only if solution is clear and seal intact.

    Store at 20º to 25ºC (68º to 77ºF) [see USP Controlled Room Temperature]

    Fresenius Kabi Logo

    www.fresenius-kabi.com/us

    45764F

    Revised: November 2020

  • PRINCIPAL DISPLAY PANEL

    PACKAGE LABEL - PRINCIPAL DISPLAY - Sodium Chloride 2 mL Single Dose Vial Label

    NDC 63323-186-04

    918602

    Sodium Chloride Injection, USP

    0.9%

    2 mL Single Dose Vial

    FOR DRUG DILUENT USE

    Preservative Free

    Rx only

    Discard unused portion.

    PACKAGE LABEL - PRINCIPAL DISPLAY - Sodium Chloride 2 mL Single Dose Vial Label
  • PRINCIPAL DISPLAY PANEL

    PACKAGE LABEL - PRINCIPAL DISPLAY - Sodium Chloride 2 mL Single Dose Vial Tray Label

    NDC 63323-186-02

    918602

    Sodium Chloride Injection, USP

    0.9%

    FOR DRUG DILUENT USE

    Rx only

    25 x 2 mL Single Dose Vials

    PACKAGE LABEL - PRINCIPAL DISPLAY - Sodium Chloride 2 mL Single Dose Vial Tray Label
  • PRINCIPAL DISPLAY PANEL

    PACKAGE LABEL – PRINCIPAL DISPLAY – Sodium Chloride 10 mL Single Dose Vial Label

    NDC 63323-186-01

    918610

    Sodium Chloride Injection, USP

    0.9%

    FOR DRUG DILUENT USE

    Rx only

    10 mL Single Dose Vial

    PACKAGE LABEL – PRINCIPAL DISPLAY – Sodium Chloride 10 mL Single Dose Vial Label
  • PRINCIPAL DISPLAY PANEL

    PACKAGE LABEL – PRINCIPAL DISPLAY – Sodium Chloride 10 mL Single Dose Vial Tray Label

    NDC 63323-186-10

    918610

    Sodium Chloride Injection, USP

    0.9%

    FOR DRUG DILUENT USE

    Rx only

    25 x 10 mL Single Dose Vials

    PACKAGE LABEL – PRINCIPAL DISPLAY – Sodium Chloride 10 mL Single Dose Vial Tray Label
  • PRINCIPAL DISPLAY PANEL

    PACKAGE LABEL – PRINCIPAL DISPLAY – Sodium Chloride 20 mL Single Dose Vial Label

    NDC 63323-186-03

    918620

    Sodium Chloride Injection, USP

    0.9%

    FOR DRUG DILUENT USE

    Rx only

    20 mL Single Dose Vial

    PACKAGE LABEL – PRINCIPAL DISPLAY – Sodium Chloride 20 mL Single Dose Vial Label
  • PRINCIPAL DISPLAY PANEL

    PACKAGE LABEL – PRINCIPAL DISPLAY – Sodium Chloride 20 mL Single Dose Vial Tray Label

    NDC 63323-186-20

    918620

    Sodium Chloride Injection, USP

    0.9%

    FOR DRUG DILUENT USE

    Rx only

    25 x 20 mL Single Dose Vials

    PACKAGE LABEL – PRINCIPAL DISPLAY – Sodium Chloride 20 mL Single Dose Vial Tray Label
  • INGREDIENTS AND APPEARANCE
    SODIUM CHLORIDE  
    sodium chloride injection
    Product Information
    Product TypeHUMAN PRESCRIPTION DRUGItem Code (Source)NDC:63323-186
    Route of AdministrationINTRAVENOUS
    Active Ingredient/Active Moiety
    Ingredient NameBasis of StrengthStrength
    SODIUM CHLORIDE (UNII: 451W47IQ8X) (SODIUM CATION - UNII:LYR4M0NH37, CHLORIDE ION - UNII:Q32ZN48698) SODIUM CHLORIDE 9 mg  in 1 mL
    Inactive Ingredients
    Ingredient NameStrength
    HYDROCHLORIC ACID (UNII: QTT17582CB)  
    SODIUM HYDROXIDE (UNII: 55X04QC32I)  
    Packaging
    #Item CodePackage DescriptionMarketing Start DateMarketing End Date
    1NDC:63323-186-0225 in 1 TRAY08/10/2000
    1NDC:63323-186-042 mL in 1 VIAL, SINGLE-DOSE; Type 0: Not a Combination Product
    2NDC:63323-186-1025 in 1 TRAY08/10/2000
    2NDC:63323-186-0110 mL in 1 VIAL, SINGLE-DOSE; Type 0: Not a Combination Product
    3NDC:63323-186-2025 in 1 TRAY08/10/2000
    3NDC:63323-186-0320 mL in 1 VIAL, SINGLE-DOSE; Type 0: Not a Combination Product
    Marketing Information
    Marketing CategoryApplication Number or Monograph CitationMarketing Start DateMarketing End Date
    ANDAANDA08891208/10/2000
    Labeler - Fresenius Kabi USA, LLC (608775388)
    Establishment
    NameAddressID/FEIBusiness Operations
    Fresenius Kabi USA, LLC840771732manufacture(63323-186) , analysis(63323-186)