Label:
MARBETA L KIT- betamethasone sodium phosphate, betamethasone acetate, lidocaine hydrochloride, bupivacaine hydrochloride...
view full title

  • Category: HUMAN PRESCRIPTION DRUG LABEL
  • DEA Schedule: None
  • Marketing Status: unapproved drug other

DISCLAIMER: This drug has not been found by FDA to be safe and effective, and this labeling has not been approved by FDA. For further information about unapproved drugs, click here.

Drug Label Information

Updated June 2, 2025

If you are a consumer or patient please visit this version.

  • HIGHLIGHTS OF PRESCRIBING INFORMATION
    MARBETA-L Kit - These highlights do not include all the information needed to use BUPIVACAINE HYDROCHLORIDE INJECTION safely and effectively. See full prescribing information for BUPIVACAINE ...
  • Table of Contents
    Table of Contents
  • BOXED WARNING (What is this?)

    WARNING: RISK OF CARDIAC ARREST WITH USE OF BUPIVACAINE HYDROCHLORIDE INJECTION IN OBSTETRICAL ANESTHESIA

    There have been reports of cardiac arrest with difficult resuscitation or death during use of Bupivacaine Hydrochloride Injection for epidural anesthesia in obstetrical patients. In most cases, this has followed use of the 0.75% (7.5 mg/mL) concentration. Resuscitation has been difficult or impossible despite apparently adequate preparation and appropriate management. Cardiac arrest has occurred after convulsions resulting from systemic toxicity, presumably following unintentional intravascular injection. The 0.75% (7.5 mg/mL) concentration of Bupivacaine Hydrochloride Injection is not recommended for obstetrical anesthesia and should be reserved for surgical procedures where a high degree of muscle relaxation and prolonged effect are necessary [see Warnings and Precautions (5.1)].

    Close
  • 1 INDICATIONS AND USAGE
    Bupivacaine Hydrochloride Injection is indicated in adults for the production of local or regional anesthesia or analgesia for surgery, dental and oral surgery procedures, diagnostic and ...
  • 2 DOSAGE AND ADMINISTRATION
    2.1 Important Dosage and Administration Information - Bupivacaine Hydrochloride Injection/Bupivacaine Hydrochloride and Epinephrine Injection is not for intrathecal use. Avoid use of Bupivacaine ...
  • 3 DOSAGE FORMS AND STRENGTHS
    Bupivacaine Hydrochloride Injection, USP is a clear, colorless solution available as: 0.25% (25 mg/10 mL) (2.5 mg/mL) in single-dose teartop vials. 0.25% (75 mg/30 mL) (2.5 mg/mL) in single-dose ...
  • 4 CONTRAINDICATIONS
    Bupivacaine Hydrochloride Injection/Bupivacaine Hydrochloride and Epinephrine Injection is contraindicated in: obstetrical paracervical block anesthesia. Its use in this technique has resulted in ...
  • 5 WARNINGS AND PRECAUTIONS
    5.1 Risk of Cardiac Arrest with Use of Bupivacaine Hydrochloride Injection in Obstetrical Anesthesia - There have been reports of cardiac arrest with difficult resuscitation or death during use ...
  • 6 ADVERSE REACTIONS
    The following clinically significant adverse reactions have been reported and described in the Warnings and Precautions section of the labeling: Cardiac Arrest in Obstetrical Anesthesia ...
  • 7 DRUG INTERACTIONS
    7.1 Local Anesthetics - The toxic effects of local anesthetics are additive. If coadministration of other local anesthetics with Bupivacaine Hydrochloride Injection/Bupivacaine Hydrochloride and ...
  • 8 USE IN SPECIFIC POPULATIONS
    8.1 Pregnancy - Risk Summary - Bupivacaine Hydrochloride Injection/Bupivacaine Hydrochloride and Epinephrine Injection is contraindicated for obstetrical paracervical block anesthesia. Its use ...
  • 10 OVERDOSAGE
    Clinical Presentation - Acute emergencies from use of Bupivacaine Hydrochloride Injection/Bupivacaine Hydrochloride and Epinephrine Injection are generally related to high plasma levels ...
  • 11 DESCRIPTION
    Bupivacaine Hydrochloride Injection contains bupivacaine hydrochloride, an amide local anesthetic, as the active pharmaceutical ingredient. The route of administration for Bupivacaine ...
  • 12 CLINICAL PHARMACOLOGY
    12.1 Mechanism of Action - Bupivacaine blocks the generation and the conduction of nerve impulses, presumably by increasing the threshold for electrical excitation in the nerve, by slowing the ...
  • 13 NONCLINICAL TOXICOLOGY
    13.1 Carcinogenesis, Mutagenesis, Impairment of Fertility - Carcinogenesis - Long-term studies in animals to evaluate the carcinogenic potential of bupivacaine hydrochloride have not been ...
  • 16 HOW SUPPLIED/STORAGE AND HANDLING
    Store at 20 °C to 25 °C (68 °F to 77 °F); excursions permitted between 15 °C to 30 °C (59 °F to 86 °F). [See USP Controlled Room Temperature.] Bupivacaine Hydrochloride Injection, USP ...
  • 17 PATIENT COUNSELING INFORMATION
    Allergic-Type Reactions - Assess if the patient has had allergic-type reactions to amide-type local anesthetics or to other formulation ingredients, such as the antimicrobial preservative ...
  • SPL UNCLASSIFIED SECTION
    This product's labeling may have been updated. For the most recent prescribing information, please visit www.pfizer.com. Distributed by Hospira, Inc., Lake Forest, IL 60045 USA - LAB-1176-5.0
  • SPL UNCLASSIFIED SECTION
    Betamethasone Sodium Phosphate and Betamethasone Acetate Injectable Suspension, USP, 6 mg/mL - 30 mg/5 mL (6 mg/mL)
  • DESCRIPTION
    Betamethasone Sodium Phosphate and Betamethasone Acetate Injectable Suspension is a sterile aqueous suspension containing 3 mg per milliliter betamethasone, as betamethasone sodium phosphate, and ...
  • CLINICAL PHARMACOLOGY
    Glucocorticoids, naturally occurring and synthetic, are adrenocortical steroids that are readily absorbed from the gastrointestinal tract. Naturally occurring glucocorticoids (hydrocortisone and ...
  • INDICATIONS AND USAGE
    When oral therapy is not feasible, the - intramuscular useof Betamethasone Sodium Phosphate and Betamethasone Acetate Injectable Suspension is indicated as follows: Allergic StatesControl of ...
  • CONTRAINDICATIONS
    Betamethasone Sodium Phosphate and Betamethasone Acetate Injectable Suspension is contraindicated in patients who are hypersensitive to any components of this product (see - DESCRIPTION) ...
  • WARNINGS
    Betamethasone Sodium Phosphate and Betamethasone Acetate Injectable Suspension should not be administered intravenously. Serious Neurologic Adverse Reactions with Epidural ...
  • PRECAUTIONS
    General - This product, like many other steroid formulations, is sensitive to heat. Therefore, it should not be autoclaved when it is desirable to sterilize the exterior of the vial. The lowest ...
  • ADVERSE REACTIONS
    (listed alphabetically, under each subsection) Allergic Reactions - Anaphylactoid reaction, anaphylaxis, angioedema. Cardiovascular - Bradycardia, cardiac arrest, cardiac arrhythmias, cardiac ...
  • OVERDOSAGE
    Treatment of acute overdose is by supportive and symptomatic therapy. For chronic overdosage in the face of severe disease requiring continuous steroid therapy, the dosage of the corticosteroid ...
  • DOSAGE AND ADMINISTRATION
    Benzyl alcohol as a preservative has been associated with a fatal “Gasping Syndrome” in premature infants and infants of low birth weight. Solutions used for further dilution of this product ...
  • HOW SUPPLIED
    NDC 0517-0720-01: Betamethasone Sodium Phosphate and Betamethasone Acetate Injectable Suspension, 5 mL multiple dose vial; box of one. Inactive ingredients per mL: 7.1 mg dibasic sodium phosphate ...
  • SPL UNCLASSIFIED SECTION
    Lidocaine HCl Injection, USP - For Infiltration and Nerve Block Including Caudal and Epidural Use. Preservative-Free - Rx only
  • DESCRIPTION
    Lidocaine hydrochloride injection, USP is sterile, nonpyrogenic, aqueous solution that contains a local anesthetic agent and is administered parenterally by injection. See - INDICATIONS AND ...
  • CLINICAL PHARMACOLOGY
    Mechanism of Action - Lidocaine hydrochloride stabilizes the neuronal membrane by inhibiting the ionic fluxes required for the initiation and conduction of impulses thereby effecting local ...
  • INDICATIONS AND USAGE
    Lidocaine hydrochloride injection is indicated for production of local or regional anesthesia by infiltration techniques such as percutaneous injection and intravenous regional anesthesia by ...
  • CONTRAINDICATIONS
    Lidocaine hydrochloride is contraindicated in patients with a known history of hypersensitivity to local anesthetics of the amide type.
  • WARNINGS
    LIDOCAINE HYDROCHLORIDE INJECTION FOR INFILTRATION AND NERVE BLOCK SHOULD BE EMPLOYED ONLY BY CLINICIANS WHO ARE WELL VERSED IN DIAGNOSIS AND MANAGEMENT OF DOSE-RELATED TOXICITY AND OTHER ACUTE ...
  • PRECAUTIONS
    General - The safety and effectiveness of lidocaine hydrochloride depend on proper dosage, correct technique, adequate precautions, and readiness for emergencies. Standard textbooks should be ...
  • ADVERSE REACTIONS
    Systemic - Adverse experiences following the administration of lidocaine hydrochloride are similar in nature to those observed with other amide local anesthetic agents. These adverse ...
  • OVERDOSAGE
    Acute emergencies from local anesthetics are generally related to high plasma levels encountered during therapeutic use of local anesthetics or to unintended subarachnoid injection of local ...
  • DOSAGE AND ADMINISTRATION
    Table 1 (Recommended Dosages) summarizes the recommended volumes and concentrations of lidocaine hydrochloride injection for various types of anesthetic procedures. The dosages suggested in this ...
  • MAXIMUM RECOMMENDED DOSAGES
    Adults - For normal healthy adults, the maximum individual dose should not exceed 4.5 mg/kg (2 mg/lb) of body weight, and in general it is recom mended that the max i m um t otal dose does ...
  • STERILIZATION, STORAGE AND TECHNICAL PROCEDURES
    Disinfecting agents containing heavy metals, which cause release of respective ions (mercury, zinc, copper, etc.) should not be used for skin or mucous membrane disinfection as they have been ...
  • HOW SUPPLIED
    Lidocaine Hydrochloride Injection, USP is supplied as follows: Lidocaine Hydrochloride Injection USP, 1% (10 mg/mL) 5 mL Single Dose Vials in a Carton of 10 NDC 55150-162-05 ...
  • Povidone-Iodine Swabsticks
  • ACTIVE INGREDIENT
    Active Ingredient                                                      Purpose - Povidone Iodine 10% w/v (9.85% w/w)                    Antiseptic
  • Purpose:
    Purpose: First aid antiseptic to help prevent skin infection in minor cuts, scrapes and burns. For preparation of the skin prior to surgery. Helps reduce bacteria that can potentially ...
  • Warnings:
    FOR EXTERNAL USE ONLY
  • Do not use:
    As a first aid antiseptic for more than 1 week. In the eyes. Over large areas of the body.
  • Ask a doctor before use if you have:
    Deep puncture wounds - Animal bites - Serious burns
  • Stop Use:
    If irritation and redness develop - If condition persists for more than 72 hours, consult a physician.
  • Keep Out Of Reach Of Children
    Keep out of reach of children.If swallowed, get medical help or contact a Poison Control Center.
  • Directions Povidone iodine:
    Tear at notch, remove applicator, use only once. As a first aid antiseptic - clean affected area - apply 1 to 3 times daily - may be covered with a sterile bandage, if bandaged let dry. For ...
  • Other information:
    Store at room temperature. Avoid excessive heat
  • INDICATIONS & USAGE
    For use as an - first aid antiseptic - pre-operative skin preperation
  • Inactive Ingredients
    Inactive ingredients: Citric acid, glycerin, polysorbate 80, sodium citrate USP, sodium phosphate dibasic, water
  • Isopropyl Alcohol 70% Prep Pads
  • Active ingredient
    Isopropyl Alcohol 70% v/v
  • Purpose
    Antiseptic
  • Uses
    For first aid to decrease germs in - minor cuts - scrapes - burns - For preparation of the skin prior to injection
  • Warnings
    For external use only - Flammable - keep away from fire or flame - Do not use - with electrocautery procedures - When using this product do not - get into eyes - apply over large areas of the ...
  • Directions
    apply to skin as needed - discard after single use
  • Other information
    Protect from freezing and avoid excessive heat
  • Inactive ingredient
    Water
  • PRINCIPAL DISPLAY PANEL
    PRINCIPAL DISPLAY PANEL - NDC: 80425-0533-01 - Rx Only - Marbeta-L™ Kit Contains - 1 Bupivacaine HCl 0.25% Single Dose Vial (10mL) 1 Betamethasone Sodium Phosphate and Betamethasone Acetate ...
  • INGREDIENTS AND APPEARANCE
    Product Information