Label: SODIUM CHLORIDE injection

  • Category: HUMAN PRESCRIPTION DRUG LABEL
  • DEA Schedule: None
  • Marketing Status: New Drug Application

Drug Label Information

Updated March 14, 2022

If you are a consumer or patient please visit this version.

  • DESCRIPTION

    Each 1 mL of 0.9% Sodium Chloride Injection USP contains:

    Sodium Chloride USP 9 mg
    Water for Injection USP qs

    pH: 5.6 (4.5-7.0)

    Calculated Osmolarity: 0.308 mOsmol/mL

    pH adjusted with Hydrochloric Acid NF

    Concentration of Electrolytes (mEq/liter):  Sodium 154       Chloride 154

    0.9% Sodium Chloride Injection USP is sterile, nonpyrogenic, isotonic and contains no bacteriostatic or antimicrobial agents.

    The formula of the active ingredient is:

     

    Ingredient

     

    Molecular Formula

     

    Molecular Weight

     

    Sodium Chloride USP

     

    NaCI

     

    58.44

    Not made with natural rubber latex, PVC or DEHP.


  • CLINICAL PHARMACOLOGY

    0.9% Sodium Chloride Injection USP provides electrolytes and is a source of water for hydration. It is capable of inducing diuresis depending on the clinical condition of the patient.

    Sodium, the major cation of the extracellular fluid, functions primarily in the control of water distribution, fluid balance, and osmotic pressure of body fluids. Sodium is also associated with chloride and bicarbonate in the regulation of the acid-base equilibrium of body fluid.

    Chloride, the major extracellular anion, closely follows the metabolism of sodium, and changes in the acid-base balance of the body are reflected by changes in the chloride concentration.

  • INDICATIONS AND USAGE

    0.9% Sodium Chloride Injection USP is indicated as pharmaceutic aid and diluent for the infusion of compatible drug additives. Refer to prescribing information accompanying additive drugs.

  • CONTRAINDICATIONS

    This solution is contraindicated where the administration of sodium or chloride could be clinically detrimental.

  • WARNINGS

    The administration of intravenous solutions can cause fluid and/or solute overload resulting in dilution of serum electrolyte concentrations, overhydration, congested states or pulmonary edema. The risk of dilutional states is inversely proportional to the electrolyte concentration. The risk of solute overload causing congested states with peripheral and pulmonary edema is directly proportional to the electrolyte concentration.

    Solutions containing sodium ions should be used with great care, if at all, in patients with congestive heart failure, severe renal insufficiency, and in clinical states in which there is sodium retention with edema. In patients with diminished renal function, administration of solutions containing sodium ions may result in sodium retention.

    Infusion of isotonic (0.9%) sodium chloride during or immediately after surgery may result in excessive sodium retention. Use the patient’s circulatory system status as a guide.

  • PRECAUTIONS

    General

    Clinical evaluation and periodic laboratory determinations are necessary to monitor changes in fluid balance, electrolyte concentrations, and acid-base balance during prolonged parenteral therapy or whenever the condition of the patient warrants such evaluation. Significant deviations from normal concentrations may require tailoring of the electrolyte pattern, in these or alternative solutions.

    Since Sodium Chloride Injection does not contain antimicrobial agents and is intended for single use, any unused amount must be discarded immediately following withdrawal of any portion of the contents of the ampoule. Do not open ampoule until it is to be used.

    This solution should be used with care in patients with hypervolemia, renal insufficiency, urinary tract obstruction, or impending or frank cardiac decompensation.

    Consult the manufactures instructions for choice of vehicle, appropriate dilution or volume for dissolving the drug to be injected, including the route and rate of injection.

    Extraordinary electrolyte losses such as may occur during protracted nasogastric suction, vomiting, diarrhea or gastrointestinal fistula drainage may necessitate additional electrolyte supplementation.

    Additional essential electrolytes, minerals and vitamins should be supplied as needed.

    Sodium-containing solutions should be administered with caution to patients receiving corticosteroids or corticotropin, or to other salt-retaining patients. Care should be exercised in administering solutions containing sodium to patients with renal or cardiovascular insufficiency, with or without congestive heart failure, particularly if they are postoperative or elderly.

    Infusion of more than one liter of isotonic (0.9%) sodium chloride per day may supply more sodium and chloride than normally found in serum, and can exceed normal tolerance, resulting in hypernatremia; this may also cause a loss of bicarbonate ions, resulting in an acidifying effect.

    To minimize the risk of possible incompatibilities arising from mixing this solution with other additives that may be prescribed, the final infusate should be inspected for cloudiness or precipitation immediately after mixing, prior to administration and periodically during administration.

    If administration is controlled by a pumping device, care must be taken to discontinue pumping action before the container runs dry or air embolism may result.

    This solution is intended for intravenous administration using sterile equipment. It is recommended that intravenous administration apparatus be replaced at least once every 24 hours.

    Use only if solution is clear and container and glass ampoule is intact.

    Carcinogenesis, Mutagenesis, Impairment of Fertility

    Studies with 0.9% Sodium Chloride Injection USP have not been performed to evaluate carcinogenic potential, mutagenic potential or effects on fertility.

    Pregnancy

    Teratogenic Effects

    Pregnancy Category C. Animal reproduction studies have not been conducted with 0.9% Sodium Chloride Injection USP. It is also not known whether 0.9% Sodium Chloride Injection USP can cause fetal harm when administered to a pregnant woman or can affect reproduction capacity. 0.9% Sodium Chloride Injection USP should be given to a pregnant woman only if clearly needed.

    Nursing Mothers

    It is not known whether this drug is excreted in human milk. Because many drugs are excreted in human milk, caution should be exercised when 0.9% Sodium Chloride Injection USP is administered to a nursing woman.

    Pediatric Use

    Safety and effectiveness of sodium chloride injections in pediatric patients have not been established by adequate and well controlled trials, however, the use of electrolyte solutions in the pediatric population is referenced in the medical literature. The warnings, precautions and adverse reactions identified in the label copy should be observed in the pediatric population.

    Geriatric Use

    An evaluation of current literature revealed no clinical experience identifying differences in response between elderly and younger patients. In general, dose selection for an elderly patient should be cautious, usually starting at the low end of the dosing range, reflecting the greater frequency of decreased hepatic, renal, or cardiac function, and of concomitant disease or other drug therapy.

    This drug is known to be substantially excreted by the kidney, and the risk of toxic reactions may be greater in patients with impaired renal function. Because elderly patients are more likely to have decreased renal function, care should be taken in dose selection, and it may be useful to monitor renal function.

  • ADVERSE REACTIONS

    Reactions which may occur because of the solution, added drugs or the technique of reconstitution or administration include febrile response, infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection, extravasation and hypervolemia. Carefully review the prescribing information for the diluted drug.

    The physician should also be alert to the possibility of adverse reactions to drug additives. Prescribing information for drug additives to be administered in this manner should be consulted.

    Symptoms may result from an excess or deficit of one or more of the ions present in the solution; therefore, frequent monitoring of electrolyte levels is essential.

    Hypernatremia may be associated with edema and exacerbation of congestive heart failure due to the retention of water, resulting in an expanded extracellular fluid volume.

    If infused in large amounts, chloride ions may cause a loss of bicarbonate ions, resulting in an acidifying effect.

    If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate therapeutic countermeasures, and save the remainder of the fluid for examination if deemed necessary.

  • OVERDOSAGE

    In the event of a fluid or solute overload during parenteral therapy, reevaluate the patient’s condition and institute appropriate corrective treatment.

  • DOSAGE AND ADMINISTRATION

    This solution is for intravenous use only.

    Dosage is to be directed by a physician and is dependent upon age, weight, clinical condition of the patient and laboratory determinations. Frequent laboratory determinations and clinical evaluation are essential to monitor changes in blood glucose and electrolyte concentrations, and fluid and electrolyte balance during prolonged parenteral therapy.

    In the average adult, daily requirements of sodium and chloride are met by the infusion of one liter of 0.9% sodium chloride (154 mEq each of sodium and chloride).

    There is no specific pediatric dose. The dose is dependent on weight, clinical condition and laboratory results. Follow recommendations of appropriate pediatric reference text. (See PRECAUTIONS, Pediatric Use.)

    Fluid administration should be based on calculated maintenance or replacement fluid requirements for each patient.

    0.9% Sodium Chloride Injection USP may also be administered intravascularly as a priming fluid in hemodialysis procedures.

    When Sodium Chloride Injections USP are used as diluents for infusion of compatible drug additives, refer to dosage and administration information accompanying additive drugs.

    Some additives may be incompatible. Consult with pharmacist. When introducing additives, use aseptic techniques. Mix thoroughly.

    Do not store.

    Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit.

  • HOW SUPPLIED

    0.9% Sodium Chloride Injection USP is supplied sterile and nonpyrogenic in glass ampoule container.

     

    NDC

     

    Size

     

    0264-9375-88

     

    10 mL

    Exposure of pharmaceutical products to heat should be minimized. Avoid excessive heat. Protect from freezing. It is recommended that the product be stored at room temperature (25°C); however, brief exposure up to 40°C does not adversely affect the product.

    Revised: May 2018

    Directions for Use of Ampoule

    To open ampoules, using gauze, place thumb and forefinger on color line, break at constriction.

    NOTE: Before use, perform the following checks:

    • Inspect each container. Read the label. Ensure solution is the one ordered and is within the expiration date.
    • Invert container and carefully inspect the solution in good light for cloudiness, haze, or particulate matter. Any container which is suspect should not be used.
    • Use only if solution is clear and container and seals are intact.
  • SPL UNCLASSIFIED SECTION

    A4800327-2

    Package Insert

     

    Rx only

     

    Manufactured for:

    B. Braun Medical Inc.

    Bethlehem, PA 18018-3524 USA

    Produced in Germany. API from Denmark.

     

    Manufactured by:

    Solupharm Pharmazeutische Erzeugnisse GmbH

  • PRINCIPAL DISPLAY PANEL

    NDC 0264-9375-88

    0.9% Sodium Chloride Injection USP

    10 mL

    Single-dose ampoule. Discard unused portion.

    Calc. Osmolarity: 0.308 mOsmol/mL

    For dilution of medication.

    For intravenous use.

    Use only if solution is clear.

    PRESERVATIVE-FREE

    Protect from freezing. Store at room

    temperature (25°C).

    Rx only

    Manufactured for:

    B. Braun Medical Inc.

    Bethlehem, PA 18018-3524 USA

    Produced in Germany, API from Denmark.

    LD-521-A-4

    LOT
    EXP 

    10 mL Ampoule Bottle label
  • INGREDIENTS AND APPEARANCE
    SODIUM CHLORIDE 
    sodium chloride injection
    Product Information
    Product TypeHUMAN PRESCRIPTION DRUGItem Code (Source)NDC:0264-9375
    Route of AdministrationINTRAVENOUS
    Active Ingredient/Active Moiety
    Ingredient NameBasis of StrengthStrength
    SODIUM CHLORIDE (UNII: 451W47IQ8X) (SODIUM CATION - UNII:LYR4M0NH37, CHLORIDE ION - UNII:Q32ZN48698) SODIUM CHLORIDE9 mg  in 1 mL
    Packaging
    #Item CodePackage DescriptionMarketing Start DateMarketing End Date
    1NDC:0264-9375-8810 mL in 1 AMPULE; Type 0: Not a Combination Product08/09/2016
    Marketing Information
    Marketing CategoryApplication Number or Monograph CitationMarketing Start DateMarketing End Date
    NDANDA01963508/09/2016
    Labeler - B. Braun Medical Inc. (002397347)