Label: GEA BI-SEPT ACTIVATOR PRE-POST MILKING NON-IODINE TEAT DIP- non-iodine teat dip liquid

CONTENTS:

ACTIVE INGREDIENT: 2.9% lactic acid

INACTIVE INGREDIENTS: 97.1%

Net Content: 5 U.S. GAL (18.9L)

KEEP OUT OF REACH OF CHILDREN

WARNING

HAZARD STATEMENT:

Causes eye irritation.

PRECAUTIONARY STATEMENTS

PREVENTION: Wear protective gloves. Wear eye or face protection. Wash hands thoroughly after handling. Refer to Safety Data sheet (SDS).

FIRST AID

If in Eyes: Flush with large volumes of water for at least 15 minutes. Call a physician immediately.
If Swallowed: DO NOT induce vomiting. Rinse mouth promptly, then give small amount/glass of water (4-6 oz. child / 10-12 oz. adult). Avoid alcohol. Call a physician immediately. DO NOT give anything by mouth to an unconscious or convulsing person.
If on Skin: Flush with large volumes of water for at least 15 minutes while removing contaminated clothing and shoes. If irritation develops and persists, get medical attention.
Inhalation of Vapors: If breathing difficulty or irritation occurs, remove to fresh air. If symptoms persist, get medical attention.

FOR ASSISTANCE WITH MEDICAL EMERGENCY

CALL 1-877-741-1032.

FOR FARM, COMMERCIAL & INDUSTRIAL USE ONLY

- NOT FOR HUMAN USE

Bi-Sept is a Trademark of GEA Farm Technologies, Inc.

Made in U.S.A.

INDICATIONS: This topical liquid product, when properly mixed with Bi-SEPT Base and used undiluted as a pre and post teat dip, effectively aids in reducing the spread of mastitis.

DIRECTIONS FOR USE: Use only when properly mixed with Bi-Sept Base. Do not dilute. Always prepare mixture in a ventilated area: add ONE volume of Bi-Sept Activatorto ONE volume of Bi-Sept Base to a clean container. Mix thoroughly. Once mixed, product can remain effective for up to three days. However, for optimum results, it is recommended to use each Bi-Sept Activator / Base mixture no longer tha 24 hours.

PRE DIPPING: Before milking, dip each teat with Bi-Sept. After 15 to 30 seconds, dry each treat thoroughly with a single service towel. If the udder and teats are heavily soiled, wash with a sanitizing solution and dry before application of Bi-Spet teat dip. 

POST DIPPING: Immediately after milking, dip each teat with Bi-Sept. Allow teats to air dry. Do not wipe. If outside temperature is below freezing, allow to air dry on the teat before the cow leaves the parlor to prevent freezing. At the end of lactation, apply this product daily for one week after the last milking. In addition, begin application of this product about one week prior to calving. If a common teat dip cup is used for application, a fresh solution should always be used at each milking. The teat dip cup should be emptied, cleaned and rinsed with potable water after each milking session or when cup becomes contaminated during milking. Do not pour remaining solution from dip cup back into original container.

STORAGE INSTRUCTIONS:

Store this product in a cool, dry area away from direct sunlight and heat to avoid deterioration. Keep containers closed to prevent contamination of this product. Keep from freezing.

NPE FREE

See accompanying label for warnings and first aid information.

7751-0094-242 (Rev. 04-17)

GEA Farm Technologies, Inc. • 1880 Country Farm Drive • Naperville, IL 60563 U.S.A • www.gea-farmtechnologies.com 

7751-0040-242

GEA Farm Technologies, Inc.

1880 Country Farm Dr.

Naperville, IL 60563 U.S.A.

630-548-8832

7751-0094-248 (Rev. 12-15)

Bi-Sept® Activator

Pre-Post Milking Non-Iodine Teat Dip