XT-1 PRE POST |PART B

DANGER

CAUSES SEVERE SKIN AND EYE IRRITATIONS

PREVENTION:  Wash skin thoroughly after handling. Wear eye protection/ face protection.

FIRST AID / RESPONSE: 

IF SWALLOWED: Rinse mouth. Do NOT induce vomiting. 

IF ON SKIN(or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower. IF INHALED: Remove person to fresh air and keep

comfortable for breathing. Immediately call a POISON

CENTER/doctor. IF IN EYES: Rinse cautiously with water for several

minutes. Remove contact lenses, if present and easy to do. Continue

rinsing. Immediately call a POISON CENTER/doctor. Wash

contaminated clothing before reuse.       

STORAGE:  Store locked up.                                      

DISPOSAL: Dispose of contents/ container to an approved waste disposal plant      

INGREDIENTS:

Sodium Chlorite     -    0.45%

XT-1 PRE POST is a two-part Chlorine Dioxide teat dip or spray and can be effectively used to reduce the spread of mastitis causing organisms. Recommended for pre and post milking applications.

Directions:

NOTE: MUST BE MIXED PRIOR TO USE. MIX PART A & PART Bin equal parts.

CREATES CHLORINE DIOXIDE. Reaches minimum Chlorine Dioxide levels within 15 minutes of mixing , and will continue to generate minimum Chlorine Dioxide of lOOO ppm for up to 5-7 days.

Directions:

General Use

Use a teat dip cup to apply.  Clean dip cup just prior to use.

If cow’s teats are sore or chapped, consult a veterinarian before starting or continuing to use teat dip.

If transferred from this container to any other, make sure that the other container is thoroughly pre-cleaned and bears the proper container labeling for this product. 

If product in dip cup becomes visibly dirty, discard contents and replenish with undiluted product. Do not reuse or return any unused product to the original container.

Teat Sprays can also be foamed or sprayed using recommended equipment.

Pre Dipping Use

Perform forestripping and inspect teats for clinical mastitis.

Pre-wash teats thoroughly just prior milking with appropriate udder wash solution or pre-milking teat dip. Teats should then be dried with single-service towels

Just before each cow is milked, dip, foam, or spray, each teat full-length into the teat dip or foam cup containing product.

Allow product to stand for 30 seconds.

Wipe teats dry after dipping, using single-service towels to avoid contamination of milk.

Post Dipping Use

Immediately after each milking, use product.

Dip each teat full-length into the teat dip cup containing product.  Allow to air dry.  Do not wipe.

If outside temperature is below freezing, allow to air dry on the teat before cow leaves the parlor.

Extended Use

When a cow is being dried off, the teats should be dipped in product, once a day for 3-4 days after the last milking.

Dipping should be resumed at least twice daily one week before calving.