FS IoBlend10
Mix Instructions
1 part IO Blend 10™ to 4 parts of water for 1% teat dip with 10% emollients.
1 part IO Blend 10™ to 9 parts of water for .5% teat dip with 5% emollients.
Hazard statement(s):
May be harmful if swallowed. May cause eye irritation.
Precautionary statement(s):
Do not eat, drink or smoke while using this product. Wear protective clothing, and eye and face protection.
Hazards not otherwise classified: None Known
FIRST AID MEASURES:
General Advice: May cause eye irritation with corneal injury and result in impairment of vision.
First Aid:
External: If irritation occurs, flush with plenty of cool, running water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse.
Eyes: Immediately flush with plenty of cool, running water. Remove contact lenses; then continue flushing for at least 15 minutes, holding eyelids apart.
Internal: Call a physician immediately. If swallowed, do not induce vomiting. Rinse mouth, then immediately drink one or two large glasses of water or milk. Never give anything by mouth to an unconscious person.
Inhalation of vapors: Should not occur with proper use of this product.
Most important symptoms/effects, acute and delayed: None known
Immediate medical attention and special treatment needed, if any: None known
IoBlend 10™ is a Concentrate Iodine teat dip designed to aid in the prevention of the spread of mastitis causing organisms.
Directions: Use full strength.
Pre-Dipping: Just before milking, make sure the teats are clean and dry. Dip each teat in undiluted EDX-1000™. Allow to soak for 15-30 seconds. Dry with a single service towel and attach milker units.
Post-Dipping: Immediately after removing inflations, dip each teat in undiluted EDX-1000™. Allow teat to air dry. Do not wipe. Replace the solution if it becomes visibly dirty.
FOR CHEMICAL EMERGENCIES: CALL CHEMTREC 1-800-424-9300
