ACTIVE INGREDIENTS:
Lactic Acid ......................................... 12.5%
Linear Alkylbenzene Sulfonate ............... 1.7%
CD X-10 Pre-Post is a two-part Chlorine Dioxide system teat dip and can be effectively used to reduce the spread of mastitis causing organisms. CD X-10 Pre-Post is designed with an emollient package ideal for skin conditoning. Recommended for pre milking applications.
HAZARD STATEMENTS
Causes severe skin burns and eye damage. Do not breathe dust/fume/gas/mist/vapors/spray. Wash face, hands, and any exposed skin thoroughly after handling. Wear protective gloves/protective clothing/eye protection/face protection.
FIRST AID
If in Eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor/physician.
If on Skin: Wash off immediately with soap and plenty of water removing all contaminated clothes and shoes. Wash contaminated clothing before reuse.
If inhaled: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a physician or Poison Control Center immediately.
If Swallowed: Rinse mouth. Get medical attention if symptoms occur.
STORAGE AND DISPOSAL
Thoroughly rinse all measuring devices and store out of reach of children. Avoid contamination of food or feed. Avoid freezing. Keep out of direct sunlight. Store in suitable labeled containers. Storage temperature: -30°C to 45°C. Store locked up. Do not mix with bleach or other chlorinated products - will cause chlorine gas. Dispose of contents/container to an approved waste disposal plant.
DIRECTIONS
IMPORTANT THIS IS A TWO-PART CONCENTRATE - MUST BE MIXED PRIOR TO USE. MIX RATIO is (48 Water: 1 Activator: 1 Base). In a clean container, add (48) parts water, then add (1) part CD X-10 Pre-Post Activator, next add (1) part CD X-10 Pre-Post Base. CREATES CHLORINE DIOXIDE.
General Use
- Use a teat dip cup to apply. Clean dip cup just prior to use.
- If cow's teats are sore or chapped, consult a veterinarian before starting or continuing to use teat dip.
- If transferred from this container to any other, make sure that the other container is thorougly pre-cleaned and bears the proper container labeling for this product.
- If product in dip cup becomes visibly dirty, discard contents and replenish with undiluted product. Do not reuse or return any unused product to the original container.
- Teat Sprays can also be foamed or sprayed using recommended equipment.
Pre-Dipping Use
- Perform forestripping and inspect teats for clinical mastitis.
- Pre-Wash teats thoroughly just prior milking with appropriate udder wash solution or pre-milking teat dip. Teats should then be dried with single-service towels.
- Just before each cow is milked, dip, foam, or spray, each teat full-length into the teat dip or foam cup containing product.
- Allow product to stand for 30 seconds.
- Wipe teats dry after dipping, using single-service towels to avoid contamination of milk.
Post-Dipping Use
- Immediately after each milking, use product.
- Dip each teat full-length into the teat dip cup containing product. Allow to air dry. Do not wipe.
- If outside temperature is below freezing, allow to air dry on the teat before cow leaves the parlor.
Extended Use
- When a cow is being dried off, the teats should be dipped in product, once a day for 3-4 days after the last milking.
- Dipping should be resumed at least twice daily one week before calving.
