CD2-10G BASE- sodium chlorite spray, metered
Wausau Chemical
Disclaimer: This drug has not been found by FDA to be safe and effective, and this labeling has not been approved by FDA. For further information about unapproved drugs, click here.
----------
Causes severe skin burns and eye damage.
Harmful to aquatic life.
Do not breathe mists.
Wash skin thoroughly after handling.
Wear protective gloves/ protective clothing/ eye protection/ face protection.
IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/ shower.
IF INHALED: Remove person to fresh air and keep comfortable for breathing. Immediately call a POISON CENTER or doctor/physician.
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor/physician.
For external use only. Not for use in sanitizing dairy equipment. Avoid contact with eyes. Avoid contact with food.
Do not mix with any other teat dip or other product. Store at room temperature and out of direct sunlight.
Avoid freezing - If product is exposed to freezing temperatures, components must be mixed thoroughly prior to use.
Store locked up.
Avoid release to the environment.
DIRECTIONS:
Measure equal volumes of CD2-10G Base and CD2 Activator into a clean dip cup/container and mix until the color is uniform throughout. Do not dilute. Mix only enough product for one milking of the herd. Dip cups should be washed after each milking.
APPLICATION:
Pre-Milking: If teats are visibly dirty, wash and dry teats with a single service towel prior to dipping. Before each cow is milked, dip the teats as far up as possible. Leave CD2-10G teat dip on teats for at least 15-30 seconds. Wipe teats dry using a single service towel before milking.
Post-Milking: Immediately after milking, dip teats at least 2/3 of their length in CD2-10G teat dip. Allow to air dry. DO NOT WIPE. CD2-10G teat dip can be used as a post-dip alone, or as a pre- and post-milking teat dip.
Always use freshly mixed, full strength CD2-10G teat dip. If product in dip cup becomes visibly dirty, discard contents and fill with fresh CD2-10G teat dip. CD2-10G teat dip may be diluted with water and safely flushed down the drain.
Note 1: If teat irritation occurs, discontinue use until irritation subsides. Consult your veterinarian and milking equipment service personnel if irritation persists.
Note 2: CD2-10G should be used with a compatible pre-dip or udder wash.
CD2-10G BASE
sodium chlorite spray, metered |
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
|
Labeler - Wausau Chemical (006136220) |
Registrant - Wausau Chemical (006136220) |
Establishment | |||
Name | Address | ID/FEI | Business Operations |
---|---|---|---|
Wausau Chemical | 006136220 | manufacture, api manufacture |