PLA-16 CONC- lactic acid, dodecylbenzenesulfonic acid, pelargonic acid solution 
Ecolab Inc.

Disclaimer: This drug has not been found by FDA to be safe and effective, and this labeling has not been approved by FDA. For further information about unapproved drugs, click here.

----------

Danger

Causes severe skin burns and eye damage.

Wash skin thoroughly after handling. Wear protective gloves/ protective clothing/ eye protection/ face protection.

Do not mix with bleach or other chlorinated products – will cause chlorine gas.

IF SWALLOWED: Rinse mouth. Do NOT induce vomiting. IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower. IF INHALED: Remove person to fresh air and keep comfortable for breathing. Immediately call a POISON CENTER/doctor. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER/doctor. Wash contaminated clothing before reuse.

DIRECTIONS:

PLA-16 CONCENTRATE MUST BE DILUTED BEFORE USE

DO NOT MIX WITH ANYTHING BUT COOL, POTABLE WATER

FOR USE ONLY IN A DISPENSING SYSTEM RECOMMENDED BY ECOLAB

Pre-Dipping Dilution Parameters: A dilute solution of a 0.5% lactic acid, 1.0% dodecyl benzene sulfonic acid and 0.1% pelargonic acid teat dip will consist of 1 part PLA-16 Concentrate and 9 parts potable water by volume.

Post Dipping Dilution Parameters: A dilute solution of a 0.5% lactic acid, 1.0% dodecyl benzene sulfonic acid and 0.1% pelargonic acid teat dip with additive will consist of 1 part Eco-Flex Additive with 12.50 parts water and 1.50 parts PLA-16 Concentrate by volume.

IMPORTANT: Never use concentrated product on teats. Once concentrated teat dip product has been properly diluted, do not further dilute with water or mix with any other teat dips. If product in dip cup becomes visibly dirty, discard contents and replenish with fresh product. Do not reuse or return any unused product to the original container.

Udder Prep: When using an udder wash step before milking, make sure to wash teats with appropriate udder wash solution using proper cleaning procedures. Teats should then be dried with single-service towels.

Application of Diluted PLA-16 Concentrate

Directions for Teat Dipping

Pre-Milk Dipping: Fill teat dip cup with diluted PLA-16 Concentrate. Before each cow is milked, dip each teat full-length into the teat dip cup containing diluted PLA-16 Concentrate. Wipe teats dry after dipping using single-service towels to avoid contamination of milk.

Post-Milk Dipping: Using fresh PLA-16 Post Dip, dip each teat full-length into the teat dip cup. Do not wipe. Allow to air dry. Do not turn cows out in freezing weather until the product is completely dry.

Directions for Teat Spraying

Pre-Milk Spraying: Before each cow is milked, spray entire teat with diluted PLA-16 Concentrate. Wipe teats after spraying using single-service towels to avoid contamination of milk.

Post-Milk Spraying: Using fresh PLA-16 Post Dip, spray entire teat immediately after each milking. Do not wipe. Allow to air dry. Do not turn cows out in freezing weather until the product is completely dry.

Expanded Usage: When freshening cows, begin dipping teats twice daily for about 10 days before calving.

PRECAUTION: PLA-16 Concentrate is not intended to cure or help the healing of chapped or irritated teats. As with any germicide, irritation or sensitization may occur in sensitive animals. In case of teat irritation or chapping, have the condition examined and, if necessary, treated by a veterinarian.

Consult your Ecolab representative for specific use instructions and recommended dispensing equipment.

FOR INDUSTRIAL USE ONLY

KEEP OUT OF REACH OF CHILDREN

NOT FOR HUMAN USE

READ SAFETY DATA SHEET (SDS) BEFORE USING THIS PRODUCT

EMERGENCY HEALTH INFORMATION: 1 800 328 0026. If located outside the United States and Canada, call collect 1 651 222 5352 (number is in the US).

Principal display panel and representative label

PLA-16 Concentrate

Teat Dip Concentrate

• Contains an emollient system

• An aid in reducing the spread of organisms which may cause mastitis

ACTIVE INGREDIENTS:

Lactic acid........................................................... ..... .......... ..... 5.0%

Dodecyl Benzene Sulfonic Acid........................................... .... 10.0%

Pelargonic Acid............................................................... ........ 1.0%

INERT INGREDIENTS.................................................................. 84.0%

(contains propylene glycol)

TOTAL....................................................... ..... ..... ................ 100.0%

Manufactured by

Ecolab · 1 Ecolab Place · St. Paul, MN 55102 USA · tel: 1 800 392 3392

© 2020 Ecolab USA Inc · All rights reserved | Todos los derechos reservados

Made in U.S.A. | Hecho en EE.UU.

773453/5301/0320

208 L (55 US GAL)

representative label

PLA-16 CONC 
lactic acid, dodecylbenzenesulfonic acid, pelargonic acid solution
Product Information
Product TypeOTC ANIMAL DRUGItem Code (Source)NDC:47593-590
Route of AdministrationTOPICAL
Active Ingredient/Active Moiety
Ingredient NameBasis of StrengthStrength
LACTIC ACID (UNII: 33X04XA5AT) (LACTIC ACID - UNII:33X04XA5AT) LACTIC ACID50 mg  in 1 mL
DODECYLBENZENESULFONIC ACID (UNII: 60NSK897G9) (DODECYLBENZENESULFONIC ACID - UNII:60NSK897G9) DODECYLBENZENESULFONIC ACID100 mg  in 1 mL
PELARGONIC ACID (UNII: 97SEH7577T) (PELARGONIC ACID - UNII:97SEH7577T) PELARGONIC ACID10 mg  in 1 mL
Inactive Ingredients
Ingredient NameStrength
WATER (UNII: 059QF0KO0R)  
PROPYLENE GLYCOL (UNII: 6DC9Q167V3)  
Packaging
#Item CodePackage DescriptionMarketing Start DateMarketing End Date
1NDC:47593-590-21208000 mL in 1 DRUM
Marketing Information
Marketing CategoryApplication Number or Monograph CitationMarketing Start DateMarketing End Date
unapproved drug other06/25/2018
Labeler - Ecolab Inc. (006154611)

Revised: 12/2020
Document Id: 955f1d7f-f215-4f03-a36a-f73910d9654f
Set id: 617c0ffb-585f-4bd5-9911-373d9ac97a22
Version: 2
Effective Time: 20201231
 
Ecolab Inc.