Mixing Directions
To make a ready-to-use solution of Ultra-Guard sanitizing barrier, add equal volumes of Ultra-Guard Base and Ultra-Guard Activator into a clean dip cup/container and mix until the color is uniform throughout. Do not dilute. Mix only amount needed for one milking of the herd. Discard any unused teat dip. Do not mix with any other products.
Recommended Procedures for teat dip sanitation
POST-MILKING (POST-DIPPING)
Immediately after milking, dip all teats full length with READY-TO-USE ULTRA-GUARD SANITIZING TEAT DIP. Ensure good coverage of all sides of the teats and teat orifices. Allow to dry. Do not wipe. Do not turn cows out in freezing weather until teat dip is completely dry.
NOTE: Before milking, use a compatile pre-dip or udder wash to thoroughy clean the teats.
Warning
Do not dilute this product.
Do not return teat dip left in the teat dipper to storage container.
Ensure that teat dips are dry before exposing the animals to weather conditions that may cause damage to the teats.
Protect this product from freezing. Store at room temperature. Always store away from direct sunlight.
First Aid
EYE CONTACT: Rinse cautiously with fresh, tepid water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing for 15 minutes. Get immediate medical advice/attention. SKIN CONTACT: For RTU products wash any sensitive areas. INGESTION: Do not induce vomiting. Never give anything by mouth to an unconscious person. Drink large amounts of water. If vomiting occurs, keep airways open. Keep head lower than the hips to prevent aspiration into the lungs. Get immediate medical advice/attention.
