Iodine............................................................... 1.00%

(Provides A Full 1% Available Iodine As Used)

Glycerine .......................................................... 10.00%
Other Inerts........... ......................................... 89.00%

(Includes Buffering Agents, Stabilizing Agents and Surfactants)
TOTAL: ............................................................. 100.00%

pH of 5.5 at the time of manufacture

1. Use teat dip applicators made of plastic or other non-corrosive materials. Do not use cups made of aluminum.
2. When solution in the teat dip cup becomes dirty and/or noticeably loses color, discard remaining contents and refill cup with fresh teat dip.
3. Do not use this product for cleaning or sanitizing equipment.
4. Wash teat dip cups after each milking.

KEEP OUT OF REACH OF CHILDREN

AVOID CONTACT WITH FOOD. DO NOT TAKE INTERNALLY

RECOMMENDED PROCEDURES FOR TEAT SANITATION:
A. PRE-MILKING (PRE-DIPPING)
1. Remove visible soils from the teats.
2. Observe formilk by stripping two or three streams of milk into a strip cup.
3. Dip or spray the cow's teats full length with Genesis 110 “SPRAY” Teat Dip.
4. Wait approximately 30 seconds.
5. Remove all teat dip by thoroughly drying the teats and teat orifices and udder (if foaming or spraying) with a clean, single service paper towels(s).
6. Attach milking unit.
B. POST-MILKING (POST-DIPPING)
1. Immediately after milking, dip or spray all teats full length with Genesis 110 “SPRAY” Teat Dip. Ensure good coverage of all sides of the teats and teat orifices.

DO NOT DILUTE THIS PRODUCT.

DO NOT RETURN TEAT DIP LEFT IN THE TEAT DIPPER TO STORAGE CONTAINER.

ENSURE THAT DIPPED OR SPRAYED TEATS ARE DRY BEFORE EXPOSING THE ANIMALS TO WEATHER CONDITIONS WHICH MAY CAUSE DAMAGE TO THE TEATS.

PROTECT THIS PRODUCT FROM FREEZING.