COMPONENT E-H WITH TYLAN- testosterone propionate, estradiol benzoate, tylosin tartrate implant 
Elanco US Inc.

----------

DESCRIPTION:

Each cartridge belt holds 20 doses of Component E-H with Tylan (testosterone and estradiol and tylosin implant) Implants. Each dose of 9 pellets consists of 8 pellets containing a total of 200 mg testosterone propionate USP and 20 mg estradiol benzoate plus 1 pellet containing 29 mg tylosin tartrate as a local antibacterial. Component E-H (testosterone and estradiol implant) Implants are recommended for use in heifers weighing 400 lbs or more for INCREASED RATE OF WEIGHT GAIN AND IMPROVED FEED EFFICIENCY.

Do not use in veal calves. Effectiveness and animal safety in veal calves have not been established.

DOSAGE:

Administer 1 implant per animal according to the following instructions.

GENERAL INSTRUCTIONS:

Study the instructions which should be followed carefully at all times, avoiding short cuts. Skin infection can be avoided by properly preparing implant site and implanter. During fly season use fly repellent on implant site. One designated team member should always do the implanting. Cleanliness of hands and instruments is important at all times.

WARNING:

Not to be used in animals intended for subsequent breeding, or in dairy animals. Implant one dose — 9 pellets (entire contents of one cartridge cell) — in the ear subcutaneously. Any other site of implantation is in violation of Federal Law. DO NOT attempt to salvage implantation site for animal feed or human food.

A withdrawal period has not been established for this product in pre-ruminating calves. Do not use in calves to be processed for veal.

RESTRICTED DRUG (CALIFORNIA) — USE ONLY AS DIRECTED — FOR USE IN ANIMALS ONLY — NOT FOR HUMAN USE — KEEP OUT OF REACH OF CHILDREN

CAUTION: For use in heifers only. Bulling, vaginal and rectal prolapse, udder development, ventral edema and elevated tail-heads have occasionally been reported in animals implanted with testosterone propionate and estradiol benzoate.

IMPLANTING INSTRUCTIONS:

Loading the Implanter

Load the implanter following the instructions supplied with each implanter.

Loading the Implanter

Restrain the Animal

Speed of implantation as well as safety of handlers is best achieved by restraining animal in a squeeze chute using head restraint. When implanting horned cattle, better control is obtained with additional use of nose tongs.

Restrain the Animal

Prepare the Implant Site

Scrub the back side of the ear (implant site) with a piece of clean absorbent cotton which has been soaked with a germicidal solution. Follow manufacturer's directions on germicide for correct strength and preparation of solution. Avoid getting disinfectant in animal's eyes.

Where to Implant

The full contents of one cartridge cell should be implanted beneath the skin on the back side of the middle one-third of the ear illustrated in the drawing. The implant must not be closer to the head than the edge of the auricular cartilage ring farthest from the head. The location for insertion of the needle is a point toward the tip of the ear and at least a needle length away from the intended deposition site. Avoid injuring the large arteries, veins and cartilage of the ear.

Where to Implant

Insert the Needle

With one hand firmly grasp the ear. With the other hand insert needle point through the skin and ease forward on a lateral plane until the entire length of the needle is under the skin.

Insert the Needle

Implant the Pellets

After inserting the needle fully in the correct position, squeeze the trigger fully as the needle is withdrawn from the ear. This properly deposits the implant in the needle track. This procedure should prevent breakage or crushing of pellets if otherwise forced into contact with tough fibrous-tissue underlying the skin. The length and total contact area of a single dose are designed to permit absorption of the hormones after implantation to stimulate good weight gain. Broken or crushed pellets may interfere with rates of gain and may lead to undesirable side effects such as noted in the CAUTION.

Clean the Needle

Clean the implanter needle with alcohol or a properly diluted germicidal solution prior to implanting the next animal.

Storage Conditions

Store at controlled room temperature 15° to 30°C (59° to 86°F)

DO NOT refrigerate – avoid excessive heat and humidity.

Discard open foil pouches.

NADA 135-906, Approved by FDA

Manufactured by a non-sterilizing process.

Component E-H with Tylan (testosterone and estradiol and tylosin implant) is covered by U.S. Patent No. 5,874,098

Component, Tylan, Elanco and the diagonal bar logo are trademarks of Elanco or its affiliates.

Distributed by Elanco US Inc, Greenfield, IN 46140, USA

Tylosin: Product of the United Kingdom

To report adverse events, access medical information, or to obtain additional product information, call 1-800-428-4441

Principal Display Panel - Component E-H With Tylan Cartridge Label

Elanco™

Component™

E-H with Tylan™

(testosterone and estradiol and tylosin implant)

HEIFERS

Component E-H with Tylan Cartridge Label

Principal Display Panel - Component E-H With Tylan Pouch Label

Elanco™

Component™

E-H with Tylan™

(testosterone and estradiol and tylosin implant)

HEIFERS

Each implant consists of 200 mg testosterone
propionate USP and 20 mg estradiol benzoate
and 29 mg tylosin tartrate

HEIFER IMPLANTS

20 dose Cartridge Belt

Component E-H With Tylan Pouch Label

Principal Display Panel - Component E-H With Tylan Carton Label

Elanco™

Component™

E-H with Tylan™

(testosterone and estradiol and tylosin implant)

HEIFERS

Component E-H With Tylan Component Label
COMPONENT E-H WITH TYLAN 
testosterone propionate, estradiol benzoate, tylosin tartrate implant
Product Information
Product TypeOTC ANIMAL DRUGItem Code (Source)NDC:58198-0338
Route of AdministrationSUBCUTANEOUS
Active Ingredient/Active Moiety
Ingredient NameBasis of StrengthStrength
testosterone propionate (UNII: WI93Z9138A) (testosterone - UNII:3XMK78S47O) testosterone propionate200 mg
estradiol benzoate (UNII: 1S4CJB5ZGN) (estradiol - UNII:4TI98Z838E) estradiol benzoate20 mg
tylosin tartrate (UNII: 5P4625C51T) (tylosin - UNII:YEF4JXN031) tylosin tartrate29 mg
Inactive Ingredients
Ingredient NameStrength
POLYETHYLENE GLYCOL 800 (UNII: UH6KR4953D)  
MAGNESIUM STEARATE (UNII: 70097M6I30)  
METHYL ALCOHOL (UNII: Y4S76JWI15)  
WATER (UNII: 059QF0KO0R)  
CROSCARMELLOSE SODIUM (UNII: M28OL1HH48)  
FD&C BLUE NO. 1 (UNII: H3R47K3TBD)  
Packaging
#Item CodePackage DescriptionMarketing Start DateMarketing End Date
1NDC:58198-0338-25 in 1 CARTON
11 in 1 POUCH
120 in 1 CARTRIDGE
Marketing Information
Marketing CategoryApplication Number or Monograph CitationMarketing Start DateMarketing End Date
NADANADA13590612/09/201306/25/2022
Labeler - Elanco US Inc. (966985624)
Establishment
NameAddressID/FEIBusiness Operations
Ivy Animal Health, Inc.088106096MANUFACTURE, LABEL, PACK
Establishment
NameAddressID/FEIBusiness Operations
Pharmacia and Upjohn Company618054084API MANUFACTURE
Establishment
NameAddressID/FEIBusiness Operations
Bayer AG314398484API MANUFACTURE

Revised: 11/2022
 
Elanco US Inc.