CAUTION
May cause eye irritation.

PRECAUTIONARY STATEMENTS
Eye protection is recommended.

FIRST AID
Eye contact: In case of contact, immediately flush eyes with cool running
water. Remove contact lenses and continue flushing with plenty of water for
at least 15 minutes. Get medical attention if irritation persists.
Inhalation: If inhaled, remove to fresh air.
Ingestion: DO NOT induce vomiting unless directed to do so by medical
personnel. Never give anything by mouth to an unconscious person. If large
quantities of this material are swallowed, call a physician immediately.
FOR EMERGENCY MEDICAL INFORMATION IN USA OR CANADA,
CALL: 1-800-328-0026.
FOR EMERGENCY MEDICAL INFORMATION WORLDWIDE,
CALL: 1-651-222-5352 (IN THE USA).

DIRECTIONS FOR USE
IMPORTANT: Do not mix Chem-Star IO-Soft 500 with water, any other teat
dips, or other products unless specified in product use instructions. If
transferred from this container to any other, make sure that the other
container is thoroughly pre-cleaned and bears the proper container labeling
for Chem-Star IO-Soft 500.
If product in dip cup becomes visibly dirty, discard contents and replenish
with undiluted product. Do not reuse or return any unused product to the
original container.
Before Milking: Wash teats thoroughly just prior to next milking with
appropriate udder wash solution or pre-milking teat dip or teat spray to
avoid contamination of milk. Teats should then be dried with single-service
towels. Use proper procedures for udder washing or pre-dipping.
Directions for Teat Dipping
Pre-Milk Dipping: Fill teat dip cup with Chem-Star IO-Soft 500. Do not
dilute. Before each cow is milked, dip each teat full-length into the teat dip
cup containing Chem-Star IO-Soft 500. Wipe teats dry after dipping, using
single-service towels to avoid contamination of milk.
Post-Milk Dipping: Immediately after each milking, use Chem-Star
IO-Soft 500 at full-strength. Dip each teat full-length into the teat dip cup
containing Chem-Star IO-Soft 500. Allow to air dry. Do not wipe. Always
use fresh, full-strength Chem-Star IO-Soft 500. Do not turn cows out in
freezing weather until Chem-Star IO-Soft 500 is completely dry.
Directions for Teat Spraying
Pre-Milk Spraying: Before each cow is milked, spray entire teat with
Chem-Star IO-Soft 500. Wipe teats after spraying using single-service
towels to avoid contamination of milk.
Post-Milk Spraying: Immediately after each milking, use Chem-Star
IO-Soft 500 at full strength. Spray entire teat with Chem-Star IO-Soft 500.
Allow to air dry. Do not wipe. Always use fresh full-strength Chem-Star
IO-Soft 500. Do not turn cows out in freezing weather until Chem-Star
IO-Soft 500 is completely dry.
Extended Usage: When freshening cows, begin dipping teats twice daily
for about 10 days before calving.
PRECAUTION:Chem-Star IO-Soft 500 is not intended to cure or help the
healing of chapped or irritated teats. As with any germicide, irritation or
sensitization may occur in sensitive animals. In case of teat irritation or
chapping, have the condition examined and, if necessary, treated by a
veterinarian.

Principal Display Panel and Representative Label

CHEM-STAR                                                                        Net Contents: 5 U.S. gal/ 18.9 L
Sanitizing Teat Dip and Spray
IO-Soft 500
0.5% Iodine Formula with Special Emollients
An Aid in Reducing the Spread of Organisms
Which May Cause Mastitis

ACTIVE INGREDIENT:
Iodine................................................................................................. 0.5%
INACTIVE INGREDIENTS.................................................................... 99.5%
(Contains an emollient system.)

KEEP OUT OF REACH OF CHILDREN

NOT FOR HUMAN USE

MEDA
S12274 Liegel Court
Spring Green, WI 53588

MANUFACTURED FOR AND DISTRIBUTED BY MILKING EQUIPMENT DEALERS ASSOCIATION, INC.