ACTIVE INGREDIENTS :
Iodine..........................................................................0.50%
(Provides A Full .5% Available Iodine as used
Inert Ingredients
INERT INGREDIENTS:
Skin Conditioners............................................................2.00%
Other Inerts..................................................................95.50%
(Includes Iodine Stabilizers, Buffering Agents and Surfactants)
TOTAL:........................................................................100.00%
pH of 5.5 at time of manufacture
This product contains highly effective levels of
free iodine for fast kill of mastitis causing organisms.
GENERAL RECOMMENDATIONS
1. Use teat dip applicators made of plastic or other non-corrosive materials. Do not use cups made of aluminum.
2. When solution in the teat dip cup becomes dirty and/or noticeably loses color, discard remaining contents and refill cup with fresh teat dip.
3. Do not use this product for cleaning or sanitizing equipment.
4. Wash teat dip cups after each milking.
CAUTION: KEEP OUT OF REACH OF CHILDREN.
AVOID CONTACT WITH FOOD. DO NOT TAKE INTERNALLY.
FIRST AID PROCEDURES
EYE CONTACT: IMMEDIATELY FLUSH EYE WITH LARGE AMOUNTS OF FRESH, TEPID WATER FOR 15 MINUTES. HOLD EYELID OPEN TO ENSURE COMPLETE IRRIGATION OF EYE AND LID TISSUES. TILT HEAD TO THE SIDE AND IRRIGATE THE EYE FROM THE BRIDGE OF THE NOSE TO THE OUTSIDE OF THE FACE.
SKIN CONTACT: FOR READY-TO-USE PRODUCTS, WASH ANY SENSITIVE AREAS.
INGESTIONS: DO NOT INDUCE VOMITING. NEVER GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON. DRINK LARGE AMOUNTS OF WATER. IF VOMITING OCCURS KEEP AIRWAYS OPEN. KEEP HEAD LOWER THAN THE HIPS TO PREVENT ASPIRATION INTO THE LUNGS.
ALWAYS SEEK IMMEDIATE MEDICAL ATTENTION
FOR MEDICAL EMERGENCIES CALL 1-800-424-9300
RECOMMENDED PROCEDURES FOR TEAT SANITATION
A. PRE-MILKING (PRE-DIPPING)
1. Remove visible soils from the teats.
2. Observe foremilk by stripping two or three streams of milk into a strip cup.
3. Dip, foam or spray the cow's teats full length with BAC-STOP NPE FREE Teat Dip.
4. Wait approximately 30 seconds.
5. Remove all teat dip by thoroughly drying the teats, teat orifices and udder (if foaming or spraying) with a clean, single service paper towel(s)
to avoid contamination of milk.
6. Attach milking unit.
B. POST-MILKING (POST-DIPPING)
1. Immediately after milking, dip or spray all teats full length with BAC-STOP NPE FREE Teat Dip. Ensure good coverage of all sides of the teats and teat orifices.
UNIVERSITY TESTED AND PASSED USING
NATIONAL MASTITIS COUNCIL PROTOCOLS
PROVEN EFFECTIVE IN REDUCING
NEW INTRAMAMMARY INFECTIONS.
