Label: VANQUISH PRE-POST ACTIVATOR- lactic acid, phosphoric acid solution

Sanitizing pre and post teat dip

Aids in reducing the spread of mastitis-causing organisms

Sanitizante pre y post ordeno

Ayuda a reducir la transmision de microorganismos que causan mastitis

ACTIVE INGREDIENTS:

Total Acid Mixture (lactic and phosporic acids) ........... 3.0%

Emollient*.............................................................. 15.0%

*from Glycerin

ACTIVATOR -

For use with only VanquishTM PrePost BASE

NPE FREE Formula

KEEP OUT OF REACH OF CHILDREN
! CAUTION
MANTENER FUERA DEL ALCANCE DE LOS NIÑOS
! CUIDADO

1012

NDC 55756-012

SI USTED NO PUEDE LEER ESTA ETIQUETA, POR FAVOR PIDA A ALGUIEN MAS QUE SE LA LEA ANTES DE USAR ESTE PRODUCTO
READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING THIS PRODUCT

FIRST AID
Contact with product can cause irritation to eyes and skin. Avoid contact with eyes and skin.

If On Skin: Flush affected area with water. Remove contaminated clothing and shoes. Get medical attention if irritation develops.

Eye Contact: Flush with water. Remove contact lenses, if present, after first 5 minutes. Then continue rinsing. Get immediate medical attention.

If Swallowed: Do not induce vomiting. If victim is fully conscious, give a cupful of water. Never give anything by mouth to an unconscious person. Get immediate medical attention.

STORAGE AND DISPOSAL

THOROUGHLY RINSE ALL MEASURING DEVICES AND STORE OUT OF REACH OF CHILDREN.  Avoid contact with food or feed.  Avoid storing near heat or open flame.  Keep container tightly closed when not in use.  If product has frozen, thaw in a warm room and shake well before use.  Do not reuse empty container.  Rinse empty container before disposing of in a safe manner.  Do not store in direct sunlight.  Do not store near chlorine or chlorinated products.

CHEM-TREC EMERGENCY NUMBER  1-800-424-9300

Not For Human Use

Additional Information on Safety Data sheet

GENERAL INSTRUCTIONS

• Use mixed solution at full strength (do not dilute).
• Do not use base or activator alone on cow teats.
• Consult your veterinarian before using a teat dip on a cow with sore or chapped teats.
• Use fresh teat dip for each milking.  Dip solution should be changed if it becomes visibly dirty, or if sediment is introduced.  Do not pour used teat dip back into original container.
• Do not use for cleaning or sanitizing equipment.
• To discard unused teat dip, dilute with water and pour down the drain.

 MIXING INSTRUCTIONS

Using a manual pump or automatic system, mix 1 part of VanquishTM Pre Post BASE and 1 part of VanquishTM Pre Post ACTIVATOR into a clean teat cup or container at least 30 minutes prior to use.  Mix product until color is uniform.  Prepare only the quantity needed for one milking.  Slight odor may be produced after mixing, ensure proper ventilation.

PRE-DIPPING

• Remove excess soil and forestrip.  (If water is used, use a minimal amount and dry thoroughly with a clean, single-service paper towel before forestripping).
• Dip teats with mixed VanquishTM Pre Post teat dip to base of udder.
• Allow a 15 to 30 second contact time.
• Dry teats thoroughly with a clean, single service paper towel.
• Attach milking unit.

POST-DIPPING

• Immediately after removing milking unit, dip or spray teats with VanquishTM Pre Post teat dip.  Do not wipe.
• If outside temperature is below freezing, allow VanquishTM Pre Post teat dip to air-dry on cow's teats before cow is released outside; or allow teat dip to remain on teats for one minute, then dry teats with a single-service paper towel.  Failure to follow these directions may result in frozen teats and injured animals.

Manufactured for: DeLaval, Inc.

11100 N. Congress Avenue

Kansas City, MO 64153

Phone: 816-891-7700

Manufactured by: WestAgro, Inc.

©2018, Made in USA

NET CONTENTS:

LOT NO.:

EXP. DATE: