DEXTROSE- dextrose monohydrate injection, solution
Baxter Healthcare Corporation
----------
Dextrose Injection, USP is a sterile, nonpyrogenic solution for fluid replenishment and caloric supply in single dose containers for intravenous administration. It contains no antimicrobial agents. Composition, osmolarity, pH, and caloric content are shown in Table 1.
Size (mL) | * Dextrose Hydrous, USP (g/L) | Osmolarity (mOsmol/L) (calc.) | pH | Caloric Content (kcal/L) |
|
5% Dextrose Injection, USP | 25 | 50 | 252 | 4.0 (3.2 to 6.5) | 170 |
Quad pack | |||||
50 | |||||
Single pack | |||||
Quad pack | |||||
Multi pack | |||||
100 | |||||
Single pack | |||||
Quad pack | |||||
Multi pack | |||||
150 | |||||
250 | |||||
500 | |||||
1000 | |||||
10% Dextrose Injection, USP | 250 500 1000 | 100 | 505 | 4.0 (3.2 to 6.5) | 340 |
The VIAFLEX plastic container is fabricated from a specially formulated polyvinyl chloride (PL 146 Plastic). The amount of water that can permeate from inside the container into the overwrap is insufficient to affect the solution significantly. Solutions in contact with the plastic container can leach out certain of its chemical components in very small amounts within the expiration period, e.g., di-2-ethylhexyl phthalate (DEHP), up to 5 parts per million. However, the safety of the plastic has been confirmed in tests in animals according to USP biological test for plastic containers as well as by tissue culture toxicity studies.
Dextrose Injection, USP has value as a source of water and calories. It is capable of inducing diuresis depending on the clinical condition of the patient.
Solutions containing dextrose may be contraindicated in patients with known allergy to corn or corn products.
Dextrose Injection, USP should not be administered simultaneously with blood through the same administration set because of the possibility of pseudoagglutination or hemolysis.
The intravenous administration of these solutions can cause fluid and/or solute overloading resulting in dilution of serum electrolyte concentrations, overhydration, congested states, or pulmonary edema. The risk of dilutive states is inversely proportional to the electrolyte concentrations of the injections. The risk of solute overload causing congested states with peripheral and pulmonary edema is directly proportional to the electrolyte concentrations of the injections.
Excessive administration of dextrose injections may result in significant hypokalemia.
In very low birth weight infants, excessive or rapid administration of dextrose injection may result in increased serum osmolality and possible intracerebral hemorrhage.
Do not use plastic containers in series connections. Such use could result in air embolism due to residual air being drawn from the primary container before administration of the fluid from the secondary container is completed.
Pressurizing intravenous solutions contained in flexible plastic containers to increase flow rates can result in air embolism if the residual air in the container is not fully evacuated prior to administration.
Use of a vented intravenous administration set with the vent in the open position could result in air embolism. Vented intravenous administration sets with the vent in the open position should not be used with flexible plastic containers.
Clinical evaluation and periodic laboratory determinations are necessary to monitor changes in fluid balance, electrolyte concentrations and acid base balance during prolonged parenteral therapy or whenever the condition of the patient warrants such evaluation.
Dextrose Injection, USP should be used with caution in patients with overt or subclinical diabetes mellitus.
Animal reproduction studies have not been conducted with Dextrose Injection, USP. It is also not known whether Dextrose Injection, USP can cause fetal harm when administered to a pregnant woman or can affect reproduction capacity. Dextrose Injection, USP should be given to a pregnant woman only if clearly needed.
Dextrose is safe and effective for the stated indications in pediatric patients (see Indications and Usage).
Newborns – especially those born premature and with low birth weight - are at increased risk of developing hypo- or hyperglycemia and therefore need close monitoring during treatment with intravenous glucose solutions to ensure adequate glycemic control in order to avoid potential long term adverse effects. Hypoglycemia in the newborn can cause prolonged seizures, coma and brain damage. Hyperglycemia has been associated with intraventricular hemorrhage, late onset bacterial and fungal infection, retinopathy of prematurity, necrotizing enterocolitis, bronchopulmonary dysplasia, prolonged length of hospital stay, and death.
Clinical studies of Dextrose Injection, USP did not include sufficient numbers of subjects aged 65 and over to determine whether they respond differently from younger subjects. Other reported clinical experience has not identified differences in responses between the elderly and younger patients. In general, dose selection for an elderly patient should be cautious, usually starting at the low end of the dosing range, reflecting the greater frequency of decreased hepatic, renal, or cardiac function, and of concomitant disease or other drug therapy.
Do not administer unless solution is clear and seal is intact.
Hypersensitivity reactions, including anaphylaxis and chills.
Reactions which may occur because of the injection or the technique of administration include febrile response, infection at the site of injection, venous thrombosis or phlebitis extending from the site of injection, extravasation and hypervolemia.
If an adverse reaction does occur, discontinue the infusion, evaluate the patient, institute appropriate therapeutic countermeasures and save the remainder of the fluid for examination if deemed necessary.
As directed by a physician. Dosage is dependent upon the age, weight and clinical condition of the patient as well as laboratory determinations.
Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration whenever solution and container permit.
All injections in VIAFLEX plastic containers are intended for intravenous administration using sterile equipment.
The dosage selection and constant infusion rate of intravenous dextrose must be selected with caution in pediatric patients, particularly neonates and low birth weight infants, because of the increased risk of hyperglycemia/ hypoglycemia. Frequent monitoring of serum glucose concentrations is required when dextrose is prescribed to pediatric patients, particularly neonates and low birth weight infants. The infusion rate and volume depends on the age, weight, clinical and metabolic conditions of the patient, concomitant therapy and should be determined by the consulting physician experienced in pediatric intravenous fluid therapy.
Additives may be incompatible. Complete information is not available.
Those additives known to be incompatible should not be used. Consult with pharmacist, if available. If, in the informed judgment of the physician, it is deemed advisable to introduce additives, use aseptic technique. Mix thoroughly when additives have been introduced. Do not store solutions containing additives.
Dextrose Injection, USP in VIAFLEX plastic container is available as follows:
Code | Size (mL) | NDC | Product Name |
25 | |||
2B0080 | Quad pack | 0338-0017-10 | 5% Dextrose Injection, USP |
50 | |||
2B0086 | Single pack | 0338-0017-41 | 5% Dextrose Injection, USP |
2B0081 | Quad pack | 0338-0017-11 | |
2B0088 | Multi pack | 0338-0017-31 | |
100 | |||
2B0087 | Single pack | 0338-0017-48 | 5% Dextrose Injection, USP |
2B0082 | Quad pack | 0338-0017-18 | |
2B0089 | Multi pack | 0338-0017-38 | |
2B0061 | 150 | 0338-0017-01 | |
2B0062 | 250 | 0338-0017-02 | |
2B0063 | 500 | 0338-0017-03 | |
2B0064 | 1000 | 0338-0017-04 | |
2B0162 | 250 | 0338-0023-02 | 10% Dextrose Injection, USP |
2B0163 | 500 | 0338-0023-03 | |
2B0164 | 1000 | 0338-0023-04 |
Exposure of pharmaceutical products to heat should be minimized. Avoid excessive heat. It is recommended the product be stored at room temperature (25°C/77°F); brief exposure up to 40°C/104°F does not adversely affect the product.
For Information on Risk of Air Embolism - see Precautions
Tear overwrap down side at slit and remove solution container. Some opacity of the plastic due to moisture absorption during the sterilization process may be observed. This is normal and does not affect the solution quality or safety. The opacity will diminish gradually. Check for minute leaks by squeezing inner bag firmly. If leaks are found, discard solution as sterility may be impaired. If supplemental medication is desired, follow “To Add Medication” directions below.
Baxter Healthcare Corporation
Deerfield, IL 60015 USA
Printed in USA
07-19-69-268
Rev. November 2013
Baxter, PL 146, and Viaflex are trademarks of Baxter International Inc.
Container Label
LOT
EXP
5% Dextrose
Injection USP
2B0061
NDC 0038-0017-01
150 mL
Each 100 mL contains
5 g DextroseHydrous
USP pH 4.0 (3.2 to 6.5)
Osmolarity 252 mOsmol/L (calc)
SterileNonpyrogenic Single dose
container Read package insert for full
information Additives may be
incompatible Dosage Intravenously as
directed by a physician Cautions
Squeeze and inspect inner bag which
maintains product sterility Discard if
leaks are found Must not be used in
series connections Do not administer
simultaneously with blood Do not
useunless solution is clear Rx Only
Store unit in moisture barrier overwrap
at room temperature(25°C/77°F) until
ready to use Avoid excessive heat See
insert
Viaflex container PL146 plastic
BAXTER VIAFLEX and PL 146 are
trademarks of Baxter International Inc
For product information 1-800-933-0303
Baxter
Baxter Healthcare Corporation
Deerfield, IL 60015 USA
Made in USA
Carton Label
2B0061
36-150 ML
VIAFLEX(R) CONTAINER
5% DEXTROSE INJECTION, USP
SECONDARY BAR CODE
(17) YYMMOO (10) XXXXX
PRIMARY BAR CODE
(01) 5030338017015
EXP
XXXXX
LOT
XXXXX
Container Label
LOT
EXP
2B0063
NDC 0038-0023-03
DIN 00060364
10% Dextrose
Injection USP
500 mL
Each 100 mL contain 10 g Dextrose Hydrous USP
pH 4.0 (3.2 to 6.5) Hypertonic Osmolarity 505
mOsmol/L (calc) Sterile Nonpyrogenic Single dose
container Additives may be incompatible Consult with
pharmacist if available When introducing additives use
aseptic technique Mix thorouhly Do not store
Dosage Intravenously as directed by a physician See
cirections Cautions Squeeze and inspect inner bag
which maintains product sterility Discard if leaks are
found Must not be used in series connections Do not
administer simultaneously with blood Do not use
unless solution is clear Rx Only Store unit in
moisture barrier overwrap at room temperature
(25°C/77°F) until ready to use Avoid excessive heat
See insert
Viaflex container PL 146 plastic
BAXTER VIAFLEX and PL 146 are trademarks of
Baxter International Inc
For product information 1-800-933-0303
Baxter logo
Baxter Healthcare Corporation
Deerfield, IL 60015 USA
Made in USA
Distribute in Canada By
Baxter Corporation
Toronto Ontario Canada
Carton Label
2B0063Q
24-500 ML
VIAFLEX(R) CONTAINER
10% DEXTROSE INJECTION, USP
SECONDARY BAR CODE
(17) YYMMOO (10) XXXXX
PRIMARY BAR CODE
(01) 50303380023030
EXP
XXXXX
LOT
XXXXX
DEXTROSE
dextrose monohydrate injection, solution |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
DEXTROSE
dextrose monohydrate injection, solution |
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
|
Labeler - Baxter Healthcare Corporation (005083209) |
Establishment | |||
Name | Address | ID/FEI | Business Operations |
---|---|---|---|
Baxter Healthcare Corporation | 059140764 | ANALYSIS(0338-0017, 0338-0023), LABEL(0338-0017, 0338-0023), MANUFACTURE(0338-0017, 0338-0023), PACK(0338-0017, 0338-0023), STERILIZE(0338-0017, 0338-0023) |